BK 7.5 cm Pak 40

The 7.5 cm PaK 40 (7.5 cm Panzerabwehrkanone 40) was a German 7.5 centimetre anti-tank gun developed in 1939-1941 by Rheinmetall and used during the Second World War. PaK 40 formed the backbone of german anti-tank guns for the latter part of World War II.

History

Development of the PaK 40 began in 1939 with development contracts being placed with Krupp and Rheinmetall to develop a 7.5 cm anti-tank gun. Priority of the project was initially low, but Operation Barbarossa in 1941 and the sudden appearance of heavily armoured Soviet tanks like the T-34 and KV-1, increased the priority. The first pre-production guns were delivered in November 1941.[citation needed] In April 1942, Wehrmacht had 44 guns in service. By 1943 the PaK 40 formed the bulk of the German anti-tank artillery.

The PaK 40 was the standard German anti-tank gun until the end of the war, and was supplied by Germany to its allies. Some captured guns were used by the Red Army. After the end of the war the PaK 40 remained in service in several European armies, including Albania, Bulgaria, Czechoslovakia, Finland, Norway, Hungary and Romania.

About 23,500 PaK 40 were produced, and about 6,000 more were used to arm tank destroyers. The unit manufacturing cost amounted to 2200 man-hours at 12000 RM. A lighter automatic version, the heaviest of the Bordkanone series of heavy calibre aircraft ordnance as the BK 7,5 was used in the Henschel Hs129 aircraft.

Performance

The weapon was effective against almost every Allied tank until the end of the war. The PaK 40 was much heavier than the PaK 38, decreasing its mobility to the point where it was difficult or impossible to move without an artillery tractor on boggy ground.

The PaK 40 debuted in Russia where it was needed to combat the newest Soviet tanks there. It was designed to fire the same low-capacity APCBC, HE and HL projectiles which had been standardized for usage in the long barreled Kampfwagenkanone KwK 40 main battle tank-mounted guns. In addition there was an APCR shot for the PaK 40, a munition which eventually became very scarce.

The main differences amongst the rounds fired by 75 mm German guns were in the length and shape of the cartridge cases for the PaK 40. The 7.5 cm KwK (tank) fixed cartridge case is twice the length of the 7.5 cm KwK 37 (short barrelled 75 mm), and the 7.5 cm PaK 40 cartridge is a third longer than the 7.5 cm KwK 40.

The longer cartridge case allowed a larger charge to be used and a higher velocity for the Armour Piercing Capped Ballistic Cap round to be achieved. The muzzle velocity was about 790 m/s (2,600 ft/s) as opposed to 750 m/s (2,500 ft/s) for the KwK 40 L/43. This velocity was available for about one year after the weapon's introduction. Around the same time, the Panzer IVs 7.5 cm KwK 40 L/43 gun and the nearly identical Sturmkanone (StuK) 40 L/43 began to be upgraded with barrels that were 48 calibers long, or L/48, which remained the standard for them until the end of the war.

In the field, an alarming number of L/48 cartridge cases carrying the hotter charge failed to be ejected properly from the weapon's semi-automatic breech, even on the first shot (in vehicles).[citation needed] Rather than re-engineer the case, German Ordnance reduced the charge loading until the problem went away. The new charge brought the muzzle velocity down to 750 m/s, or about 10 m/s higher than the original L/43 version of the weapon. Considering the average variability in large round velocities from a given gun, this is virtually negligible in effect.[citation needed] The first formal documentation of this decision appears on May 15, 1943 ("7.5cm Sturmkanone 40 Beschreibung") which details a side by side comparison of the L/43 and the L/48 weapons. The synopsis provided indicates very little difference in the guns, meaning the upgrade had little if any benefit.

All further official presentations of the KwK 40 L/48 ( "Oberkommando des Heeres, Durchschlagsleistungen panzerbrechender Waffen") indicate a muzzle velocity of 750 m/s for the gun. As for the PaK 40, the desire for commonality again appears to have prevailed since the APCBC charge was reduced to 750 m/s, even though case ejection failures apparently were never a problem in the PaK version of the gun.

For reasons which seem to be lost to history, at least some 75 mm APCBC cartridges appear to have received a charge which produced a muzzle velocity of about 770 m/s (2,500 ft/s). The first documented firing by the U.S. of a PaK 40 recorded an average muzzle velocity of 776 m/s for its nine most instrumented firings.[4] Probably because of these results, period intelligence publications ("Handbook on German Military Forces") gave ~770 m/s as the PaK 40 APCBC muzzle velocity, although post war pubs corrected this (Department of the Army Pamphlet No. 30-4-4, "Foreign Military Weapons and Equipment (U) Vol. 1 Artillery (U) dated August of 1955-this document was originally classified).

In addition, German sources are contradictory in that the Official Firing Table document for the 75 mm KwK 40, StuK 40, and the PaK 40 dated October, 1943 cites 770 m/s on one of the APCBC tables therein, showing some confusion. ("Schusstafel fur die 7.5cm Kampfwagenkanone 40").

SCREENSHOOT


SPECIFICATIONS

Type Anti-tank gun
Place of origin  Nazi Germany
Service history
In service 1942–1945
Used by  Nazi Germany
 Finland
 Kingdom of Hungary
 Norway (postwar)
Wars World War II
Production history
Designer Rheinmetall
Designed 1939–1941
Manufacturer Rheinmetall
Produced 1941–1945
Number built Approx. 23,500
Specifications
Weight 1,425 kg (3,140 lb)
(in action)
Length 6.2 m (20 ft 4 in)
Barrel length 3.45 m (11 ft 4 in)

Shell 75×714 mm. R
Caliber 75 mm (2.95 in) L/46
Breech semi-automatic horizontal sliding block
Carriage split trail
Elevation -5° to +22°
Traverse 65°

0 comments:

Post a Comment